New product

Victron Phoenix 16A 24 Volt Battery Charger 2 Banks Plus 1 Start Bank Marine and RV




The Victron Phoenix 24 Volt 16 Amp Battery Charger is a fully adaptive 4 stage Charger that uses Bulk, Absorption, Float and Storage to ensure long term optimum performance and life for your battery. The Victron Phoenix 24 Volt 16 Amp Battery Charger has two outputs to be able to charge two battery banks and one fixed 4 Amp output (2+1). 

Adaptive 4-stage charge characteristic: bulk – absorption – float – storage

The Phoenix Charger features a microprocessor controlled ‘adaptive’ battery management system that

can be preset to suit different types of batteries. The ‘adaptive’ feature will automatically optimise the

process relative to the way the battery is being used.


The right amount of charge: variable absorption time

When only shallow discharges occur (a yacht connected to shore power for example) the absorption time is kept short in order to prevent overcharging of the battery. After a deep discharge the absorption time is automatically increased to make sure that the battery is completely recharged.


Preventing damage due to excessive gassing: the BatterySafe mode

If, in order to quickly charge a battery, a high charge current in combination with a high absorption

voltage has been chosen, the Phoenix Charger will prevent damage due to excessive gassing by

automatically limiting the rate of voltage increase once the gassing voltage has been reached .


Less maintenance and aging when the battery is not in use: the Storage mode

The storage mode kicks in whenever the battery has not been subjected to discharge during 24 hours. In

the storage mode float voltage is reduced to 2,2 V/cell (13,2 V for 12 V battery) to minimize gassing and

corrosion of the positive plates. Once a week the voltage is raised back to the absorption level to

‘equalize’ the battery. This feature prevents stratification of the electrolyte and sulphation, a major cause of early battery failure.


To increase battery life: temperature compensation

Every Phoenix Charger comes with a battery temperature sensor. When connected, charge voltage will

automatically decrease with increasing battery temperature. This feature is especially recommended for

sealed batteries and/or when important fluctuations of battery temperature are expected.


Battery voltage sense

In order to compensate for voltage loss due to cable resistance, Phoenix Chargers are provided with a

voltage sense facility so that the battery always receives the correct charge voltage.


Universal 90-265 V AC input voltage range and also suitable for DC supply (AC-DC and DC-DC


The chargers will accept a 90-400 V DC supply.


Computer interface

Every Phoenix Charger is ready to communicate with a computer through its RS-485 data port. Together

with our VEConfigure software, which can be downloaded free of charge from our website.

Amps50 Amps


3 other products in the same category: